APPLYING PAINT WITH THE TRAYLESS PAINT SYSTEM
Squeeze the pump handle several times and watch to be sure you see paint flowing through the hose
to the Paint Roller Assembly. (NOTE: If you don’t see paint flowing after repeated pumping, check
all hose and attachment connections and be sure there are no kinks in hose.) As the paint begins
seeping out of the roller (or accessory attachment), begin applying to surface. Continue pumping as
needed to keep paint supplied to the roller (or accessory attachment).
Note that the pump handle can be configured to operate at 3 different settings by adjusting the
position of the tabs located on the underside of the handle:
Full Stroke
- With both tabs up (parallel with the handle), the pump will operate with a full
stroke and highest volume of paint delivered. This is the optimum setting for the Paint Roller.
1/2 Stroke
- With the Small tab rotated to the down position (parallel with the pump shaft), the
pump will operate with a 1/2 stroke, delivering a medium volume of paint. This is the optimum
setting for the Large Paint Pad and Large Corner Brush
1/4 Stroke
- With the Large tab rotated to the down position (parallel with the pump shaft), the
pump will operate with 1/4 stroke and the lowest volume of paint will be delivered. This setting
is suitable for the Small Paint Pad and Small Corner Brush.
4
5
PREPARATION FOR USE
Setting up the Paint Roller Assembly
The Paint Roller Assembly is suitable for painting larger areas. Check to make sure foam roller is
inserted fully onto the roller shaft of the Paint Roller Handle. Retainer Clip should be flipped up so the
tab holds the roller in place on the handle. See diagrams below:
Setting up the Accessory Attachments
For painting smaller areas such as trim and moulding, or for painting in confimed
areas, use the Small or Large Paint Pads. For painting into corners, use the Small
or Large Corner Brushes. Set up for all of these is the same.
Accessory attachments are used in conjunction with the Accessory Handle. Insert
desired attachment into end of Accssory Handle, making sure tabs on attachment
align correctly with notches in end of handle. Rotate 1/4 turn clockwise to lock in
place.
Connecting to Hose
Connect either the Paint Roller Assembly or the Accessory Handle to Hose by inserting it into the
hose end, making sure tabs on handle align correctly with notches in hose end. Rotate 1/4 turn
clockwise to lock in place.
Preparing the Paint Container
1. Remove pump assembly from Paint Container by unscrewing the retainer ring located just above
belt clip.
2. Attach Funnel Cup to paint container and fill with paint leaving some space at the top. NOTE: Do
not fill completely or paint will overflow when you place the pump assembly back into container.
3. Place pump assembly back into container and secure in place with the retaining ring.
4. With hose fully uncoiled, hang the Paint Container Assembly on your belt. If you will be painting
with your right hand, place the container on your left side so you can pump with your left hand; if you
will be painting with your left hand, place the container on your right side.
Incorrect
Incorrect
Correct
1/4
1/2
FULL