6
Cargo Max assembly - Step 4
eleCTriCAl AsseMBly
The majority of the wiring is already pre-installed within the frame. The
following steps outline how to run the last of the wiring through the tongue
using the pre-installed “wire fish”.
1. Attach the flat four prong end of the wire harness to the fish
at the rear end of the tongue under the trailer.
2. Locate the end of the wire fish on the coupler end of the
tongue and pull the flat plug up through the hole until the
strain relief is just inside the grommet hole, and place the
grommet over the wire harness and insert into the hole in
the tongue with the slit toward the trailer.
HinT:
Wetting the grommet with water will make for easier
installation.
WArning! do noT oVer-Pull!
PULL
