1. Bed & frame
150-01557-01
(wired w/side, clearance, tail lights)
AsseMBled
2. Axle & hubs
AsseMBled
550-07277-00
3. Tongue
AsseMBled (WiTH Wire FisH)
150-01556-01
4. Tongue clamp
AsseMBled
150-01558-00
5. Limiter strap
AsseMBled
149-01702-01
6. Tongue jack
AsseMBled
551-09901-00
7. Tailgate ramp
AsseMBled
149-00523-01
8. Fenders (2)
005-55810-00
9. Tires (2)
550-00007-00
10. Tailgate ramp latch brackets (2)
005-70022-00
11. Corner supports (2)
PS: 150-70003-00 DS: 150-70004-00
12. Teflon isolation strips (2)
005-05910-00
13. Grommet
003-40000-00
14. License plate bracket
008-83207-00
15. Shrinkwrapped hardware card (not shown)
001-70026-01
Cargo Max assembly - Step 1
AsseMBling THe Axles & Tires - PArT one
1. Locate the axle isolation strips packed in the assembly
components kit.
2. Place an isolation strip on the two inside surfaces of the axle
mount as shown in FIG. 1A.
TiP: Tape will aid in holding the strips in place.
3. Place the trailer frame on the axle mounts, aligning the holes
in the axle mount with the front two holes in the frame. Note
the orientation of the torsion arms in FIG. 1B.
4. Next, insert (2) 1/2-13 x 3-1/4” bolts through the bottom
holes on the fender support brackets as shown in FIG. 1B.
5. Fasten with (2) flat washers and (2) nylock nuts. Make sure
that the axle mount, teflon strip, and axle beam are tight
together with no gap before tightening.
Torque to 80 FT/lBs.
3
