Floe 510-27100-00, Инструкция по сборке и руководство пользователя

Страница: 12 / 16

SHEET 12 OF 16
WITH THE CAPS REMOVED FROM THE DOCK, USE A FLOE SPEED WRENCH OR 1-1/8” SOCKET AND
CORDLESS DRILL, ADJUST THE HEIGHT OF THE DOCK SO THE BOTTOM FRAME OF THE DOCK IS
APPROXIMATELY 8” ABOVE THE WATER. *SEE NOTE ON SHEET 1. TURN THE DOCK ADJUSTING NUT
ON THE TOP OF THE DOCK CLOCKWISE TO LOWER THE DOCK AND COUNTERCLOCKWISE TO
RAISE THE DOCK. USE A LEVEL TO MAKE SURE ALL DOCK SURFACES ARE LEVEL (FIGURE 3.7). ONCE
THE DOCK IS SET IN PLACE AND LEVELED, INSERT THE PLASTIC CAPS IN THE ADJUSTMENT NUT HOLE
(FIGURE 3.8).
FIGURE 3.7
FIGURE 3.8
2X
NEVER ADJUST YOUR DOCK LEGS WITH AN
IMPACT WRENCH. IF YOU CAN NOT TURN
THE ADJUSTING NUT, DO NOT FORCE IT –
YOU HAVE REACHED THE END OF THE
ADJUSTMENT RANGE. DO NOT EXCEED 15
FT-LBS. APPLYING TOO MUCH FORCE TO
YOUR DOCK LEGS WILL DAMAGE THE
MECHANISM.
CORDLESS DRILL MAY COME TO A
SUDDEN STOP WHEN THE LEG IS
FULLY EXTENDED OR RETRACTED.
BE SURE TO HAVE YOUR
CORDLESS DRILL IN CLUTCH
MODE WHEN ADJUSTING THE
LEGS. USE OF A CORDED DRILL
MAY CAUSE ELECTROCUTION.
FAILURE TO USE DRILL IN CLUTCH
MODE MAY CAUSE INJURY TO
YOUR HAND OR ARM.