Flo-tech mc4000, Руководство пользователя

Страница: 9 / 28

Operation
Programming Menu
Press
MENU
to open the programming menu . Continue to press
MENU
to scroll through the user settings and measurement
parameters on the display . Press
UP
or
DOWN
to scroll through the options available for each parameter . Press
OK
to store
any new settings, the display will read DATA STORED . Press
ESC
to scroll backwards through the menu choices . Press
ESC
three
times to return to measuring mode .
Datalogger
The datalogger parameter allows you to start, stop or delete recorded measurement sessions .
DATALOGGER
STORE OFF
This command stops recording the datalogging information to memory . Press
OK
to stop
an active datalogging session . The screen will display DATA STORED .
DATALOGGER
STORE ON
This command starts recording data at a selected interval rate, see "Save Interval" below .
Each record automatically adds the date and time from an internal real time clock . To start a
new datalogging session press OK . The screen will display DATA STORED .
DATALOGGER
STORE DELETE
This command deletes all stored data . To delete data press
OK
, the unit will display ERASE
DATA? Press
OK
again to confirm the request . The screen will display DATA ERASED .
The internal memory can save all displayed measurements and permits 224 individual records at a total capacity of 2 .5 MB .
To start a new datalogging session, press
OK
at the
STORE ON
prompt . After starting a new datalogging session, press
ESC
to
switch the display to measuring mode . In measuring mode, an
M
icon indicates an active datalogging session, see
Figure 5
.
Stored datalogging sessions can be uploaded to a computer, using the USB data port, for further processing .
P1 bar
74.32
T °C
86.5
Q l/min
38.4
P2 bar
76.12
M
Logging Active
Indication
Figure 5: Active datalogging session display
Save Interval
The save interval is the time between two consecutive recording cycles set in fixed increments as shown below .
SAVE INTERVAL
1 s
Selection Function
1s, 2s, 5s, 15s, 30s,
60s, 120s, 300s, 600s,
1200s, 1800s, 2700s,
3600s, 7200s
This command sets the time, in seconds, between two recording
cycles . Press UP or DOWN to scroll through each interval, when
the correct interval is displayed, press OK to select the interval . The
screen will display DATA STORED .
Page 9 February 2015 TST-UM-00017-EN-03