FLIR Raymarine i70s, Инструкция по установке и эксплуатации

Страница: 40 / 114

7.1 Transducer types
The transducers listed in the table below can be
calibrated using the display.
Transducer type Connection
Depth transducers connected via iTC-5 or Depth
pod
Speed and temperature
transducers connected via iTC-5 or Speed
pod
Wind transducers connected via iTC-5 or Wind
pod
Smart transducers connected directly to SeaTalk ng®
Fluxgate compass connected via iTC-5
Rudder reference connected via iTC-5
7.2 Depth calibration
Depth Offset
Depths are measured from the transducer to the
bottom, you can apply an offset value to the depth
data, so that the displayed depth reading represents
the depth to the bottom from either the keel (negative
offset) or the waterline (positive offset).
Before attempting to set a waterline or keel
offset, find out the vertical separation between the
transducer and either the waterline or the bottom
of your vessel’s keel, as appropriate. Then set the
appropriate depth offset value.
D9343--2
1 2 3
1 Waterline offset Values greater than zero (Positive
values) represent a waterline offset
2 Transducer Zero offset represents the depth
from the transducer’s location
3 Keel offset Values less than zero (Negative
values) represent a keel offset
Setting the depth offset
The depth calibration consists of setting a Depth
Offset that is relevant to your depth transducer’s
installed location.
From any favorite page:
1. Select
Menu .
2. Select Set-up .
3. Select Transducers Set-up .
4. Select Continue .
The instrument display will search for and display
a list of connected devices. (i.e. iTC-5, DST or
transducer pod)
5. Select the device that the transducer(s) you are
calibrating are connected to.
A list of available transducer data is displayed,
6. * Select Depth .
Note: * Step only applicable to iTC-5.
7. Select Depth Offset .
8. Select Depth From: .
A list of transducer offsets is displayed:
• Waterline
• Keel
• Transducer (default)
40
i70s Installation and operation instructions