FLIR Raymarine CPT-S Transom, Руководство по установке

Страница: 24 / 42

5.1 Pre-installation test
Warning: Transducer operation
Only test and operate the transducer in
the water. Do NOT operate out of water
as overheating may occur.
Testing the transducer
Transducer operation should be checked before
installation.
1. Connect the transducer to the sonar module’s /
display’s transducer connection.
2. Fully submerge the transducer in water.
3. Power up the sonar module / display.
4. Open a Fishfinder application on your display.
5. If required, select the relevant transducer/channel
from the Channel selection page ( Menu >
Channel ).
6. Check that accurate depth and temperature
readings are displayed.
7. If you experience difficulties obtaining readings
then contact Raymarine Technical Support.
5.2 Mounting the transom mount
bracket
The transducer must be mounted on the transom
using the mounting bracket provided. The steps
below describe the initial mounting steps required
in order to test your transducers performance.
After testing the transducer you must finish the
mounting following the instructions in the
Finishing
the transducer mounting section.
1. Fix the transducer mounting template to the
selected location, using masking or self-adhesive
tape.
1
2
3
D12632-2
1 Transducer mounting template
2 Waterline
3 Mounting away from propeller
2. Ensure the template is parallel to the waterline.
3. Drill 2 x holes for the adjustment slot screws as
indicated on the template.
Note: Do NOT drill the third mounting hole at this
stage.
4. Fill the 2 holes with marine grade sealant.
5. Using a pozi-drive screw driver and the screws
provided, secure the transom mount bracket
using the 2 adjustment slots.
D13186-2
Note: The third locking screw is not used until the
transducer has been successfully tested.
24 CPT-S Transom CHIRP sonar transducer