FLIR Raymarine CAM220IP, Руководство по установке

Страница: 21 / 54

4.2 Connections overview
Use the following information to help you identify the
connections on your product.
Connector Type Connects to:
Suitable
cables
RJ45 • RayNet
network
• Multifunc-
tion display
• PC
A Network
coupler and
/ or RayNet
to SeaTalk
hs
adaptor cable
is required.
Refer to
Chapter 11
Spares and
accessories
.
Power 12 V dc power
supply
Note: The
terminator
should be
removed
to enable
connection
to a power
supply.
18AWG
minimum
thickness for
power cable
extensions.
Making connections
Follow the steps below to connect the cable(s) to
your product.
1. Ensure that the vessel's power supply is switched
off.
2. Ensure that the device being connected has
been installed in accordance with the installation
instructions supplied with that device.
3. Ensuring correct orientation, push cable
connectors fully onto the corresponding
connectors.
4. If applicable, engage any locking mechanism to
ensure a secure connection.
5. Ensure any bare ended wire connections are
suitably insulated to prevent corrosion due to
water ingress.
4.3 Power options
This product must be powered using ONE of the
following methods:
1. PoE (Power over Ethernet).
Either:
• Direct connection to a Raymarine gS Series
MFD (only one cable is required to carry both
data and power signals), or
• Connection to a suitably-powered Raymarine
or FLIR PoE injector. Only one cable is
required to carry both data and power signals
between the camera and the PoE injector.
However, the PoE itself will require its own
power source, and a separate ethernet
data cable to a laptop, Raymarine MFD, or
Raymarine network switch.
This method is useful if the camera is located a
long distance from a power source; you will only
need a single ethernet data cable to the camera
itself, and the PoE injector can be located close
to the power source.
2. Self-powered.
Direct connection to a vessel's power supply
using the supplied power cable. With this
method, a separate ethernet data cable is
required to a laptop, Raymarine MFD, or
Raymarine network switch.
Refer to the Power connection section for connection
details.
Warning: Powering PoE devices
This device can be powered over its
ethernet connection (PoE) OR via its
dedicated power cable.
NEVER connect the devices dedicated
power cable when the device is being
supplied PoE.
Cables and connections 21