427-0075-01-12 Revision 140
October 2019
10
This document does not contain any export-controlled information.
PT-Series HD Camera Installation
•
Once the mounting location has been selected, verify both sides of the mounting surface are
accessible and free of utility service lines or other obstructions.
•
Use stainless steel hardware to fasten mounts to outdoor surfaces.
•
Use a thread locking compound such as Loctite 242 or equivalent with all metal to metal
threaded connections.
•
To prevent damage from water leakage when installing outdoors, apply sealant around the bolt
holes between the mount and the mounting surface.
Step 1
Determine the correct positioning of the isolation plate (See
).
Step 2
Place the isolation plate and the camera on the mounting structure aligning the bolt holes
or studs.
Step 3
Install nylon shoulder washers (4x) or nylon flat washers (4x) onto camera base.
If using nylon flat washers, apply a generous coat of Tef-Gel filling all gaps and voids.
Step 4
Secure the camera using 5/16” or M8 fasteners (4x) with stainless steel flat washers and
split washers on top of the nylon washers.
Following this procedure is critical to maintaining the warranty on your PT-Series HD product.
Failure to follow these instructions can potentially void the camera warranty.
Table 1-1: Kit Contents
Description
Qty
1
a.
Use the alternate nylon flat washers and Tef-Gel lubricant on fasteners for PT-Series HD camera bases
with mounting holes that are too small to accept the shoulder washers. A syringe of Tef-Gel will be supplied
in the mounting kit when the nylon flat washer is required.
6
6
6
6
optional
