FLIR identiFINDER R200, Руководство пользователя

Страница: 15 / 130

A Word about Batteries
The backup battery should be maintained in accordance with battery brand recommendations (as a rule
of thumb, change annually to ensure fail safe).
Indication of battery state is provided below —
No Backup:
l
6% - 100% primary indicator with gauge 6% to 100% ,
l
5% primary indicator blinks (flashes) ,
l
1% goes to automatic shutdown screen ,
l
clicking checkmark confirms, shuts down the system .
Backup Present:
l
6% - 100% primary indicator with gauge 6% to 100% ,
l
5% primary indicator blinks (flashes) ,
l
(1% - 5%) indicator switches to backup (powered by both, until internal battery discharges) ,
l
2.0V+ backup indicator without gauge ,
l
<2.0V (~5%) backup indicator flashes ,
l
1.95V (~1%) displays automatic shutdown screen,
l
clicking checkmark shuts down unit .
In either case, the FLIR identiFINDER R200 simply powers down if battery drains completely. However,
memory and stored data remain intact and can be retrieved when power is restored.
A Note about IP67 and the Battery Door
The FLIR identiFINDER R200 is rated to IP67. The CR123A battery door needs to be
installed and fully secured to achieve this rating.
To assemble, rotate the battery door clockwise by hand until the seal of the door initially seats against
the housing. Moderate resistance will be encountered when this is achieved.
Then, use a coin or flathead screwdriver and rotate the door clockwise approximately 3/4 of a turn to fully
seal the instrument.
Status
Make a record of system status, including Serial Number (S:), ID, Firmware Build, and
available memory (record in writing, or take a screen shot by briefly pressing the
R200 3/10/2017 __ 1:38 PM 1–8