Flipper LC Two Device Universal, Инструкция по эксплуатации

Страница: 6 / 12

Automatic Code Searching:
Learning Set Up:
This method automatically sends a group of codes until
your device turns OFF. Start with either TV or STB ON.
1. Press and hold TV or STB . The light will flash once
then stay solid. Release the key.
2.
Press and release the button. The remote
will send 10-15 codes to your TV or STB. The indicator
light flashes quickly when sending, and turns solid
when complete.
3.
If your TV or STB turns OFF, the code is in that group.
If the device did not turn off, repeat until your device
turns off.
4.
Once your device turns off, wait until the indicator
light stops flashing, then press and release the
button to send one code at a time
until your device turns
ON.
5.
Once the device turns ON, press TV or STB to set and
try your device. If all buttons do not work, repeat.
Note: Some devices share codes with others. As a result, it
is possible that a code matches some but not all of your
device’s functions. If this happens, repeat the process
until the correct code controls all of your device’s function.
Flipper remote can learn function signals from your
existing remote control. This allows you to copy the
signals from your current remote into the Flipper
remote. Each key is programmed separately.
TV, STB ,
and ADD do not learn functions.
Note: Favorite channel mode may not work with Learning
set up.
1. Press and hold the TV or STB button and the
button. The indicator will flash once, then remain
flashing. Release the keys.
2.
Face your existing remote control’s signal transmitter
(on the front) to the Flipper remote transmitter, with
3-5cm gap in between the remotes.
3.
Press and release the key on Flipper remote control
that you want to program from your other remote.
hi
hi
hi
hi
hi
hi
hi
hi
ON/OFF
ON/OFF
hi
Channel Down
10
Troubleshooting
If you are experiencing difficulties with your remote
control, remember these helpful hints:
1.
Make sure the remote is unlocked, by pressing TV ,
ADD or STB . The light will flash once, then turn solid.
Then enter 956. The light will flash twice.
2.
Check to see if you are in Favorites mode or regular
mode. Press and hold DEL and dash - until the light
flashes twice and turns off. This will enter or exit
favorite channel mode.
3.
Press TV and make sure the remote is controlling
your TV. If not, reset the remote by going to Step 1 in
the recommended set up.
4.
Press STB and make sure the remote is controlling
your STB. If not, reset the remote by going to Step 2 in
the recommended set up.
5.
Restore the original factory settings. Press and hold
ADD until the light flashes once then turns solid, then
enter 954. The light will be solid, then flash twice. If
settings remain in the remote, also do the same with
TV and STB.
hi
hi
hi
hi
hi
The
indicator
light will turn solid. Each key is
programmed separately.
4.
Press and release the same key from your existing
device remote until you see the light on the Flipper
remote start flashing again. The learning process for
that key is done.
5.
Keep repeating step 1-4 until you learn all the keys
you want.
6.
Press the TV or STB button to set the remote.
7. Check the buttons to see if they learned the correct
signal. If not, repeat the process as needed until all
buttons learn the desired function.
Note: The remote can learn functions for any IR remote
control, including a stereo.
hi
hi
hi
hi
hi
11