Document Number:
MAN – DAPS440-SW
Rev:
D
Revision Date:
09/14/2010
Page 5 of 15
Specifications
Dimensions
9.5”(W) x 1.25”(H) x 7.25”(D)
Video System
NTSC/PAL
Input Sources
4 Audio/Video Channels
Output Sources
4 Audio/Video Each
Control Sequence
Source 1,2,3,4
Video Impedance
75 Ohms
Audio Impedance
8.2 KOhms
Weight
1 lb 8 oz
Power
28VDC @ 1.0 Amps
Remote Control
Via Eaton Switch (Not Supplied)
Mounting
6 Points on Flange
Source Selection
Switch(es):
Eaton (58210220) or Staco (982431)
Materials
Aluminum
D0-160
Section 21, Category B
Installation Instructions
All cabin entertainment equipment, such as the DAPS440-SW, should be installed on a
non-essential bus and have a dedicated circuit breaker. It is a requirement that a switch be
installed so that the pilot can de-energize the system should it become necessary.
There are six mounting slots located on the sides of the housing. Four holes are located at
the four corners of the back and two holes are located one on each side of the flange. It is
sufficient to mount the unit by two attach points. It is recommended that you leave about
¼
inch of space around the unit for air circulation.
Audio/Video inputs are paired and listed on the same side of the unit as the Power Input
DB-15. From left to right the video/audio inputs are line 1,2,3,4. Use the inputs
sequentially as you would like them selected by the operator.
On the opposite side of the unit is the output side. Here you will find four paired output
jacks.
Power
This is a
28VDC
device that requires 1.0 Amps of power to operate.
All manuals and user guides at all-guides.com
