7.1.3. Once lamp is positioned correctly, slide the lamp holder inward toward the
center of thebulb to secure and lock the lamp in place as shown in photo F and
photo G. Please note: Do not force the lamp holders closed. This could cause
damage to both the lamp and lamp holders.
7.1.2. Begin by installing the double- ended lamp within the lamp holders shown in
photo B and photo C. Please note: When installing lamp, do not apply excessive
force. The wire end/lead must be fully seated as shown in photo D and photo E
before sliding both socket ends closed. During installation try to minimize exces-
sive handling of the lamp to minimize fingerprints and oils left on the lamp. If the
lamp needs cleaning, use a soft dry cotton cloth to wipe off fingerprints or oils.
•
•
•
•
•
•
8. WARNING
Failure to follow our guidelines could result in electrical shock.
Do not touch, move, spray, or clean your light fixture when it is plugged in.
Allow it to cool down before handling.
Recommended mounting clearance for your fixture is 8"-12" on all sides.
Do not mount directly to any surface.
Make sure to disconnect the power when changing the lamp.
7.2.1. Make sure your unit is unplugged.
7.2.2. Hang the fixture from a strong cord or chain from both ends. Make sure you
have hooks solidly screwed into the studs in the ceiling. If you cannot locate the
studs, insert expansion anchors into the ceiling. The hooks should be rated to hold at
least 50 lbs each.
7.2 HANGING YOUR FIXTURE
