Model HC170. Issue Number 8. Date 17.01.2022.
4
6.
Setting the temperature
The machine will remember the temperature it was set to during its last operation.
Don’t
need to change the temperature? Please move to stage 7.
Need to change the temperature? Follow the 3 steps below. The display will run through a self-test programme
for the first few seconds after switching on the system, this is normal.
1.
Press the ‘P’ button on the display once. ‘SP
-
1’ (set point) will be displayed in red at the top of the display.
2.
Using the up and down arrow, select the required temperature in green. 8-10°C is usual.
3.
Press the ‘P’ button again to set the system. The machine will cool the circulating fluid to this
temperature The temperature of the fluid is shown by the red display and the green shows the set point.
7.
Turning off the system
Switch off the unit at the black rocker switch, remove the hose (the alarm will sound which is normal) and
unplug the machine. A few drops of the fluid will be lost from the connectors, this is normal.
IMPORTANT: Always allow the cooling pads to warm back up to room temperature before folding to pack away
as this will increase the life of the pads.
8.
Warning lights, alarm and topping up the CuddleBlanket unit with Coldflow2 fluid
The alarm will sound and the red LED light will illuminate if there is an obstruction to flow or if the reservoir is
low on fluid. (Fig.1)
The reservoir should always be kept topped up during operation. Leave the unit switched on, remove the filler
cap and top up slowly. (Fig.2)
Fig.1
Fig.2
