Flexit Spirit K2R, Руководство пользователя и инструкции по установке

Страница: 5 / 24

5
2 Cleaning/Maintenance
1. Hold the door by its upper edge, which has a recessed
grip.
2. Pull the door to release it from its catch.
3. Change your grip and lift the door off.
NB! the door
weighs 10 kg.
For user
Fans:
The fans
must
be cleaned once a year. Clean the fan
blades with a grease solvent on a cloth - or with brush and
compressed air if possible. NB! Do not use water.
Dismantle the fan as follows: Open the doors as instructed.
EC fan: Release the screw at the front of the fan. Pull out the
electric quick-release contact for the motor. The fan can
now be pulled carefully down and out of the unit.
AC fan: Pull the fan out half way. Pull out the contact behind
the fan. The fan can now be pulled out.
Filters:
To preserve a healthy indoor air quality, it is important to
change filters when they are dirty. Dirty filters lead to:
How often the filters need to be changed depends on the
degree of contamination of the air where they are installed.
In general, the filters need to be changed once a year,
preferably in the autumn (after the pollen season). In areas
with a lot of dust and contamination, the filters should be
changed in the spring and autumn. The supply air filter and
extract air filter consist of a compact filter (F7). These are
pushed into place.
It is recommended that you order a filter subscription to
ensure full benefit from the system and the cheapest prices.
When changing the filter, check that the whole unit
is working normally.
Rotor:
As the unit has filters with a high impermeability class
installed, it is not usually necessary to clean the rotor. If
for various reasons it should still be necessary, dust can
be removed with a soft brush. Further cleaning is possible
if you remove the rotor, spray it with fat-soluble detergent
and then blow it clean from the opposite side. Distance
approximately 60mm and max. pressure 8,0 bar. Ensure that
the motor is not exposed to water during cleaning. Ensure
that all seals around the rotor are intact and tight.
external cleaning:
Many kitchen surface cleaners contain chemicals that
may damage the product’s plastic components. Therefore
use a soft cloth moistened with warm water and a neutral
detergent to clean the outside of the product.
important!
Do not use abrasive cleaners or scouring
powder, as they will damage the colour. Products that give
stainless steel an anti-fingerprint coating must not be used
either.
Before opening the door of the heat recovery
unit or carrying out maintenance on the kitchen
hood: switch off the heat, let the fans continue for three
minutes to remove hot air, disconnect power from the
unit and wait 2 minutes before opening the doors.
!
Increased air resistance in the filter – less air in
the home – risk of bacterial growth in the filter
– in the worst case scenario, the system can be
damaged.
!
Remember that the door is heavy (10 kg) when
lifting it off the unit.
!
1
2
3
Fig. 2
Remember first to remove the safety lock at the
top of the door.
!
safety lock