Flexit K2.1, Руководство по установке

Страница: 18 / 28

18
K 2 . 1
ON OFF
)LJ
&RQȴJXUDWLRQ Setting
CI 600 (MASTER) Automatic
CI 60 1 (SLAVE) OFF
CI 60 2 (SLAVE) ON
CI 60 1 (MASTER) OFF
CI 60 2 (SLAVE) ON
CI 600 (MASTER) Automatic
CI 60 (SLAVE) Irrelevant
8.2. INSTALLATION OF CI60/600
CAUTION! The control panel must
be connected to the ventilation
unit before the ventilation unit is
connected to mains.
i
Lay the cable for the control panel between the
ventilation unit and the control panel. The control
panel is adapted for concealed installation over a single
connection box (use low back piece, item no. 2) or
surface installation on the wall (use high back piece, item
no. 3).
INFO! Click the cable into the
contact at the back of the control
panel and into the contact on the
top of the ventilation unit.
i
!
NOTICE! The low-voltage cable
must be at least 30 cm from cables
carrying mains voltage or higher.
With concealed installation, the
cable is laid in 20 mm conduit
pipes. The cable length must not
exceed 24 meters.
It is possible to connect two CI60 panels and one CI600
panel to each unit. If several CI60 panels are used, each
panel must have its own identity. This is selected with
the switch on the panel’s printed circuit board (se Fig. 7).
Use the appropriate table settings. The panels can be
connected serially, in arbitrary order.
OFF = MASTER
ON = SLAVE