04
1
1
6
7
A
B
B
x8
A
4x4
Step 4
Longer end
Longer end
Longer end
Longer end
Shorter end
Shorter end
Shorter end
Shorter end
Turn the legs upside down. Attach the feet (1) to the bottom of the legs using eight M6x16mm
bolts (B) and tighten with 4x4 hex key (A). Please note: Keep the longer end of the feet (1) and
side bracket (6&7) on the same side.
Please keep the feet and side brackets on the same direction of shorter end.
F
E
E
x4
F
x4
Connect the arms (3&4) with two cross bars (5) using four M6x30mm bolts (E) and fully attach with
the four knobs (F). Choose proper screw holes according to the actual size of work surface.
Please keep the feet and side brackets on the same direction of shorter end.
05
Step 3
Step 5
Step 6
Note: Work surface is separately available for purchase.
Place the worksurface and attach it to the side brackets (6&7) using eight St4.2x20mm screws
and tighten with drill.
Tips: Remain the distance to the edge and mark them on the board.
Install the control box (8) and handset to the worksurface as shown on picture using six St4.2x20mm
screws and tighten with drill.
Please note: place the handset within the length range of the cable.
D
x6
8
6
D
D
x8
Step 7
8
Interface for
handset cable
11
10
12
Connect the handset cable (9), power cord (10) and motor cable (11) to the control box as shown on
the picture.
Turn on the power and use the desk in accordance with the instructions.
Interface for
motor cable
Interface for
power cord
Connecting Arms
Handset cable
Use the cable ties to fix and organize the cables
7
9
D
D
E
F
5
5
