manual
www.fl xiforce.com
page 3
K
e
ypad/Card reader
manual
www.fl xiforce.com
page 3
5. Deleting registered cards
Press
30 - swipe card - #
the swiped card is now deleted
Press
31 - “card number” #
the card with that number is now deleted
Press
32 - 9999 - #
all cards are now deleted
6. Setting the access mode
Press
40 #
card or personal code to access (default)
Press
41 #
card AND personal code to access
Press
42 #
personal code only
8. Program personal access code
Press
6 “new code” # “new code” #
must be a 6 digit code
Press
6 # #
personal access code is deactivated
9. Exiting program mode
Press
*
10. Changing the card password (only needed when in card AND personal code mode)
The 9700V12/24 recognizes a different pass code for the ‘card AND personal code’ mode. In other words:
this code is not the same as the regular pass code.
Press
*
(green LED will go ON) -
swipe card - “old password (default is 888888)
” (red and green LED flash
alternating)
“new password” # “new password” #
Green LED will be OFF and you’ll hear two short (Di Di) signals to confirm. In case of failure to program
you’ll hear a long (Di) signal. Try again.
11. Back to factory settings
Cut off power. Put jumper JP1 in 2-3 position. Re-connect to power. After you hear two short (Di Di) signals,
put jumper JP1 in position 1-2.
Examples of programming:
1. Change program password to 789000:
a. enter program mode by pressing
#### 123456 #
(green LED flashes)
b. press
0 789000 # 789000 #
c. press
*
(to exit program mode)
2. Add new cards in a continuous way:
a. enter program mode:
#### 123456 #
(green LED flashes)
