8. Install IP65 Grip Connectors
Coat the open end of the strip and approximately 1” of the top of the strip in silicone sealant. (Due to the dome shaped nature
of the strip, sealant does need to be applied to the top to fill in the gaps on the sides.) Slide the transparent case of your Outdoor
IP65 Grip connector into the sleeve, until the strip is making proper contact with the end of the clear plastic. Then, grab the
white plastic part of your connector and push the metal contacts through the window of the transparent case. Adjust it with
pliers until you hear a click, and then let the sealant cure according to its own instructions.
9. Apply Silicone Sealant
Open your silicone sealant and apply generously around the end of the connector to ensure that any gaps are filled between the
strip and the connector to create a watertight seal.
10. Retest the Setup
Test the strips again to make sure they all light up and are functioning properly before the final installation. Once you have
verified all segments are working, you’re ready to install them.
11. Strip Light Pre-install Preparation
Thoroughly clean any surface where you will be attaching your LED strip lights. The adhesive backing is strong, but will not stick
to surfaces if they are dirty or dusty.
04
UltraBright™ Valor Premier Diffusion Series LED Strip Light
Installation Guide