FlexDSL Telecommunications AG
Steinackerstrassse 31
8902 Urdorf
Switzerland
Page 4/6
Tel: +41 44 741 52 90
Fax: +41 44 741 52 93
Email: [email protected]
Web: www.flexdsl.ch
Connector Description
SHDSL Technical Specification
SHDSL Connector Specification
Specification
ITU-T G.991.2 G.shdsl and G.shdsl.bis
Pin No
Description
Line Code
TC-PAM16/32, Extended: TC-PAM4/8/64/128
1
SHDSL interface A
Impedance
135
Ω
2
SHDSL interface A
Transmit Power
13.5 (Annex A) or 14.5 (Annex B) dBm @ 135
Ω
3
SHDSL interface B
Number of Pairs
2
4
SHDSL interface B
Bit Rate
192 to 5704kbit/s, Extended: 128 to 15232kbit/s
Overvoltage Protection
ITU-T Rec. K.20/K.21
Connector Type
Phoenix Mini Combicom
MC 1,5/4-GF-3,5 (female), 4 pins.
Matching Type for the cable FK-MCP 1,5/ 4-STF-3,5
For AWG 16-26, Area 0.14–1.5 mm
2
or Diameter
0.4-1.4 mm
Fiber Optic Technical Specification (100Base-FX)
SFP Connector
Standard
IEEE-802.3, VLAN/QoS IEEE-802.1q/p
Number of Interfaces
1
Data Rate
100BaseT, Full/Half Duplex, Ethernet
Connector Type
Type –SFP Tyco 1658391-1
Recommended 155Mbps SFP Transceiver (Fast Ethernet, OC-3, STM-1):
LS38-A3S-TC-N
XGSF-03-1503-80
Ethernet Technical Specification
Ethernet Connector Specification
Standard
IEEE-802.3, VLAN/QoS IEEE-802.1q/p
Pin No
Description
Number of Interfaces
2 or 1
1
Tx+ (transmit data)
Data Rate
10/100BaseT, Full/Half Duplex
2
Tx- (transmit data)
Protocols
Data, Telnet, SNMP, WEB
3
Rx+ (receive data)
Signal Level
Ethernet
4
NC (not used)
MDI/MDI-X auto crossover
Supported
5
NC (not used)
Auto Negotiation
Supported
6
Rx- (receive data)
Connector Type
RJ45 Female, 8 pin
7
NC (not used)
8
NC (not used)
Monitor/Local Craft Terminal Technical Specification
Monitor/LCT Connector Specification
Specification
USB V2.0 full and low speed
Pin No
Description
Data Rate
12Mbit/s
1
+5V
Protocol
Master/Slave, Uses the USB communication
2
Data -
device class (CDC) drivers to take advantage of
3
Data +
the installed PC RS-232 software to talk over the
4
NC (not used)
USB
5
SGND
Connector Type
USB Type Mini-B female connector
Power Supply Technical Specification
Power Supply Connector Specification
Specification
ETSI ETS 300 132-2
Pin No
Description
Voltage (-24V models)
18-72VDC local power
1
Negative power terminal or
N (Neutral power terminal)
Voltage (-230V models)
85-264VAC, 120-370VDC local power
2
Protection ground
Connector Type
Phoenix Combicom
MSTB 2,5/ 3-GF-5,08(male), 3 pins.
3
Positive power terminal or
L (Life power terminal)
Matching Type for the cable FKCT 2,5/ 3-STF-5.08
For AWG 12-24, Area 0.2–2.5 mm
2
or Diameter
0.5-1.75 mm
Power Consumption
Typically 4 Watts
