—6—
—7—
Alligator
®
Staple Gold Class
™
Plus
AVERAGE TRIGGER PULLS
Fastener
Size
Average
Trigger Pulls for:
Initial
Drive
Final
Set
RS62
1-2
1-2
RS125
2-3
2-3
RS187
3-4
3-4
Note:
Number of trigger pulls will
vary depending on belt thickness and
durometer. Do not overdrive staples.
13. Return the handle into the initial position
and lock it down. Release Cam Levers and
remove belt from the tool.
14. Using Belt Nippers, notch corners of
trailing edge. Notch at an angle as shown.
15. Bring belt ends together and insert hinge
pin. If retaining washer is used, crimp with
pliers. Splice is complete.
1
3
3
2
2
10. Follow the sequence shown above to
drive all remaining fasteners. Staples will be
partially clinched.
11. Squeeze both release handles to allow the
tool to change position.
12. Move the handle from initial position
into final position to move anvil into
finishing position. Repeat steps 9 & 10.
Refer to chart below for average trigger pulls.
Alligator
®
Ready Set
™
Staple Fasteners Selection Chart
Fastener
Size
Operating
Tension
Range
Belt
Thickness
Range
Min.
Pulley
Diameter
Approx.
Hinge Pin Diameter
P.I.W.
kN/m
in.
mm
in.
mm
in. (nylon-steel)
mm (nylon-steel)
RS62
100
17
1/16-1/8
1.5-3.2
2
50
nylon .080, steel .080
nylon 2.0, steel 2.0
RS125
160
28
1/8-3/16
3.2-4.8
3
75
nylon .141, steel .141
nylon 3.6, steel 3.6
RS187
200
35
3/16-1/4
4.8-6.4
4
102
nylon .203, steel .187
nylon 5.2, steel 4.7
Maintenance Tips
• Clean tool with brush only.
• DO NOT use air pressure.
• Add lubricant as required.