www.flexco.com
—6—
Alligator
®
Staple Gold Class
™
Plus
1. Do not remove regulatory whip assembly.
Connect the Alligator® Staple Gold Class™
Driver to a clean, dry air line with a
maximum incoming pressure of 120 PSI.
The driver regulator will bring air source
down to 70 PSI. Oil air line with one to two
drops prior to use.
2. (a) Square belt ends.(b) Cut belt using a
Flexco belt cutting tool.
3. (a) Skive rough-top belt using Flexco
skiving products. Select correct fastener size
by using the chart on page 7.
4. Make sure the tool is in initial position.
This position is when the handle is all the
way back and locked.
5. To change fastener size setting, pull both
pins from the tool base.
6. Move template so corresponding
fastener size matches the base hole. Then
reinsert both pins.
LOCK
5
UN
LO
CK
PUSH
R8 187
R8 62
R8 125
7. Center fastener strip in the tool.
Fastener Strip should be tight against tool.
(a) Cam lever(s) should be up. Center belt
in installation tool, equal distance between
belt ends.
8. (a) Belt end should be tight against
the fastener belt stops. (b) Depress cam
lever(s).Fastener top should lean forward.
If not, tighten handle clockwise to increase
pressure and repeat. To prevent damage to
the tool, do not overtighten cam levers.
9. Starting with the center fastener plates,
insert the nose of the Alligator Staple Gold
Class Driver into the guide block. Note: the
driver must be firmly seated into the pin
to activate safety switch. DO NOT depress
tool trigger before tool is seated completely
down on top of guide block, as this will
damage the tool. Apply adequate number
of trigger pulls to produce sufficient staple
leg fold. Refer to chart on page 7. Drive
remaining staples as follows.
Operation