Flex XFE 7-12 80, Оригинальная инструкция по эксплуатации

Страница: 18 / 236

XFE 7-12 80
18
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Attaching or changing the tool holder

Pull out the mains plug.

Hold the Velcro plate. Loosen the hexa
-
gon socket head bolt in anti-clockwise
direction using a hexagon key SW4 and
remove the Velcro plate.

If necessary clean profile spindle.

Place guide of new Velcro plate on profile
spindle (must engage and fit positively).

Mount a new Velcro plate on the profile
spindle. To do this, hand-tighten the hexa
-
gon socket head bolt in clockwise direction.
Attach or change tools

Pull out the mains plug.

Centre the polishing tool on the Velcro
plate and press it on firmly. Use undama
-
ged polishing tools only.

Perform a test run to check that the polis
-
hing tool is centred and does not vibrate.
Operating instructions
CAUTION!
When the power tool is switched off, the tool
continues running briefly.
NOTE
Following a tool change (e.g. change from
polishing sponge to lambswool), a diffe
-
rence in weight can cause higher vibrations.
Adjust the working speed via the setting
wheel until the vibrations are reduced.
– Switch on the electric power tool before
applying it to the surface to be polished and
allow it to run until the speed has settled.
– Apply light pressure to the polishing tool
and make circular, overlapping move
-
ments on the surface to be polished in