Flex TRINOXFLEX BME 8-4, Оригинальная инструкция по эксплуатации

Страница: 26 / 404

TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
26
Attaching tool
The tool holder enables the tool to be
changed without any tools.

Pull out the mains plug.

Press and hold down the spindle lock (1.).

Push tool or tool support onto the tool
holder (tongue and groove form fit) (2.).

Press the tool downwards against the
spring pressure (3.) and turn clockwise (4.).
The tool holder is locked.
NOTE
The tool holder has a width of 50 mm.
Depending on the tool width, several tools
must be attached or differences in width
must be equalised with the spacer rings.
Example:

Insert the mains plug into the socket.

Switch on the electric power tool (without
locking the button) and leave it running for
approx. 30 seconds. Check for imbalances
and vibrations.

Switch off the electric power tool.
Using the parallel guide
The parallel guide ensures exact straight
running when machining profiles.

Loosen the locking screw on the parallel
guide (1.).

Adjust the parallel guide (2.).

Re-tighten the locking screw.
Work instructions for the burnishing
attachment
CAUTION!
When the appliance is switched off, the
grinding tool continues running briefly.
Machining flat areas:

Hold electric power tool with both hands.
To give the surface a decorative finish:

Carefully place the electric power tool on
the area to be machined and move the
power tool forwards and backwards in
a linear motion.
Polishing wheel 50 mm
wide:
1 tool
Buffing wheel 10 mm
wide:
4 tools and
spacer rings