Flex MT 18.0-EC, Руководство пользователя

Страница: 15 / 180

MT 18.0-EC
15
– Emission value a
h,M
(cutting sheet metal):
< 2.28 m/s 2
– Uncertainty: K = 1.5 m/s
2
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 62841 and may be used to compare one
tool with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emission
level represents the main applications of the
tool. However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
exposure level over the total working period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use. This may
significantly decrease the exposure level over
the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
Technical specifications
TOOL
MT 18.0-EC C
MT 18.0-EC
MT 18.0-EC/5.0 Set
U Vdc 18
n
o
/min 10000-20000
m (w/o battery) kg 1.3
Battery AP 2.5 AP 5.0
Weight of
battery/kg
0.42 0.72
Working
Temperature
-10 – 40 ℃
Storage
Temperatur e
less than 50
℃
Charging
Temperature
0-40 ℃
Charger CA 10.8/18.0, CA 18.0
Overview (see figure A)
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Accessory release lever
2 On/off switch
3 Speed control panel
4 Led work light
5 Neck
6 Accessory holder
7 Clamping jaws
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the multi tool and check that here are
no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.
Inserting/replacing the battery
(See figure B)
■
Press the charged battery into the power
tool until it clicks into place.
■
To remove, press the release button and
pull out the battery.
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!