Rotational laser
23
Checking precision
Caution!
The power tool may be adjusted by
authorised technicians only.
n
Place the power tool 10 m from a wall.
n
Switch on the machine.
Operating mode: rotating laser beam.
n
Mark the position of the laser beam (X)
on the wall.
n
Rotate the power tool by 180° (tripod
recommended).
n
Mark the position of the laser beam (Y)
on the wall.
The centre between the two marks (X) and
(Y) is the correct value from which the two
marks must not deviate by more than 2 mm/
10 m.
n
To check the precision, rotate the power
tool by 90° and repeat the entire
process.
Maintenance and care
Cleaning
If the power tool is damp after use, wipe the
power tool and accessories with a dry, soft
cloth.
Do not use solvents or abrasive cleaning
agents to remove dirt. Use a clean cloth
moistened with water and a mild detergent.
Remove dust from the laser beam discharge
window (2, 1) with a soft paint brush, etc.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Accessories
Disposal information
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2002/96/EG on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Note!
Please ask your dealer about disposal
options!
Spare-part/Accessory
Order
no.
Laser visibility glasses (improved
visibility of the laser beam)
312.134
Wall and ceiling holder (ALR)
312.088
Clamping column
312.096
Elevator tripod, medium-sized
(0.65–2.00 m)
312.118
Elevator tripod, large
(0.90–2.85 m)
312.126
ALR512.book Seite 23 Mittwoch, 18. Januar 2006 9:57 09
