Fitting the key safe
To fit your Filex CR you will need the following tools:
•
Power Drill
•
5mm Masonry Drill Bit
•
Small Socket Driver
•
8mm Socket Head
•
Marker Pen
NOTE: Your Filex CR should be fitted to a solid surface. We
recommend brickwork, stone, concrete or steelwork
To start use the rubber cover as your template to mark the
fixing holes on the wall. Ensure you choose a location that
allows the best possible fixing e.g. the centre of a brick. N.B.
You must never fix into the mortar.
•
Now use the 5mm drill bit to make a hole 55mm deep in
each of the marked fixing holes
•
Place the Filex CR inside the rubber case
•
Open the door of your Filex CR and place the whole unit
onto the wall lining up the holes.
•
Push the fixing bolts that have been supplied with your
Filex CR into each of the holes
•
Tighten each bolt fully using a socket set
Troubleshooting
•
Once the fitting is complete if the door closes but does
not lock, test locking it when the door is in the open
position. If it works, it is likely that the fixing bolts are
protruding too far into the Filex CR. Try to secure them
further into the wall and close the door again.
•
If the buttons will not press, ensure that the dial is in
the vertical position
•
If your code does not work, press the ‘CLEAR’ button
and start again
FILEXSECURITY.COM
