Changing your code
•
Open your Filex CR as normal
•
Remove the screw securing the black plastic plate with a small flat-headed screwdriver
•
You will need to turn the disk of each number in your previous code until the arrow faces
the NOT SET position
•
You can now repeat all of
the steps in the section marked ‘SETTING YOUR CODE’ and
‘CHECKING YOUR CODE’
Opening your key safe
•
Ensure that the dial is in the vertical position (shown in the
image below)
•
Enter your code
•
If you enter your code wrong, press and slide the clear button
down and then release the button. You can now re-type your
code
•
Rotate the dial clockwise 360 degrees, until it clicks
•
Pull the door open
Locking your key safe
•
Close the door and lock it by turning the dial anti-clockwise 360 degrees. It should click
at least once
•
Ensure that it has locked properly by turning the dial clockwise 360 degrees
•
until it clicks. Try and open the door, if it does not open your Keyguard XL is now fully
secure
•
Close the lid of the rubber cover
Trouble shooting
•
The dial must be in the vertical position to use the code buttons
•
If your code hasn’t worked, ensure you press the ‘CLEAR’ button before entering the code
again
•
Ensure that the arrow on the dial of each button is in the SET position when setting your
code
•
Ensure that all numbers not in your code have their dials facing the NOT SET position
•
Ensure that the black plastic plate is properly and securely refastened
•
You may find that when you turn the dial you feel some resistance, do not worry, this is
normal.
