Hanger is not fully installed.
(a) There is too much clearance
between the picture frame and
the ram tip at its extended
position.
(b) There is not enough air
pressure.
(a) Using the detent knobs on
either side of the drive carriage,
lower the height setting to an
appropriate range. A ¼”
clearance is sufficient.
(b) Increase air pressure until the
hanger is fully installed.
Hanger is not centered (left-
right).
The fence is not positioned
properly.
Refer to page 9 in order to review
measurement settings.
Hanger is not centered (up-
down).
The hanger need not be centered
vertically on the top edge of the
frame. However, if the hanger is
not placed where the operator
wants it, there is likely a problem
with the measurements reflected
on the scale on Scale B.
Refer to page 9 in order to review
measurement settings.
Hanger strip does not feed
properly.
(a) The hanger strip may be
slightly bent or twisted.
(b) The flow control valve is
closed or clogged.
(a) The hanger strip can be fed
with minimal misshape, however,
it should be manually corrected if
possible. If the strip is badly bent,
the strip needs to be replaced.
(b) Adjust the flow control valve
to let more air into the indexing
cylinder.
Frame will not release.
There may have been less than
¼” clearance between the ram tip
and the picture frame.
Using the detent knobs on both
sides of the carriage, raise the
ram to an appropriate height
setting range. A ¼” clearance is
necessary to avoid trapping the
frame.
For assistance, contact The Fletcher-Terry Company Customer Service Department at
800.843.3826, 860.677.7331, or [email protected]
.
ÿþýü úù
