FLEETWOOD RV Class A Gas 2020, Руководство пользователя

Страница: 136 / 176

134
Water Systems
SECTION SEVEN
To Attach the Sewer Hose:
• Remove sewer hose from storage .
• Remove termination cap . Align coupler tangs with
termination tabs . Twist coupler clockwise 90º locking
coupler to termination drain .
• Unscrew access port and feed the sewer hose
through the opening .
• Attach other end of hose to shore sewer facility .
Restrain hose to prevent movement during use .
• Open the liquid waste drain (grey water) valve .
The solid waste drain (black water) valve remains
closed until the tank is full or until time of departure to
help prevent clogging . Use the outside faucet or shower
attachment for washing or rinsing the sewer hose after
dumping the black tank .
DRAINING THE TANKS
The waste holding tanks should be full or nearly full prior
to draining to help evacuate the tanks more efficiently .
To Drain the Tanks:
1 . Attach sewer hose to termination drain and shore
facility .
2 . Prepare to dump the solid waste (black) tank first .
Close the liquid waste drain (grey) valve .
3 . Fill the grey tank to at least 50% by running water
in the shower or sinks . Use the tank monitor panel
to observe tank fluid levels . When the grey tank is
50% full, stop filling the tank .
4 . Secure the drain hose to prevent movement . Open
the solid waste drain (black) valve . Allow the black
tank to drain .
5 . Flush the black tank using the Tank Flush fitting
in the water service center . Flush the tank for
approximately 2-3 minutes .
6 . When complete, close the black water valve .
7 . Open the grey water valve . The water in the grey
tank will flush remaining solids from the sewer
hose . With the grey water valve open, run two
gallons of water down any drain to flush grey tank .
The grey valve remains open until the next drain
cycle, or time of departure .
Preparing for Travel:
1 . Close solid waste (black) and liquid waste (grey)
valves .
2 . Undo restraining devices from the sewer hose .
Disconnect the sewer hose from the termination
drain by rotating the fitting counterclockwise 90º .
3 . Raise the sewer hose and using hand over hand
method working the sewer hose towards the shore
fitting .
4 . Rinse the sewer hose with outside facility and
repeat the hose drain process .
5 . Remove the sewer hose from shore fitting .
6 . Store the sewer hose .
7 . Secure the termination cap to the termination drain
(required by law in some states) .
8 . If desired, add chemicals to the tanks to control odor .
Follow the directions given by the manufacturer of
the chemical .
040422j
Typical Termination Valves
Gray Water Valve
Black Water Valve
NOTE:
Use care when connecting the sewer hose adapter
to the termination drain in cold weather .
NOTE:
Close the grey water valve 24 hours prior to
departing to allow the tank to fill with liquid to help
in the dumping process .