FLEETWOOD RV BOUNDER, Руководство пользователя

Страница: 18 / 97

BOUNDER CLASSIC INFORMATION
LAMPS AND BULBS
Interior - 12-volt
Ceiling double incandescent ......GE 1141, 12-volt
Ceiling single incandescent........GE 1141, 12-volt
Vanity light ....................................9019-F, 12-volt
Round Halogen lights........................10W, 12-volt
Ceiling Halogen lights ......................10W, 12-volt
Exterior
Back-up lights ............................GE 1156, 12-volt
Entry step light.............................GE 194, 12-volt
Front clearance lights...................GE 194, 12-volt
Front side marker/turn signal..........Sylvania 3457
Headlight, halogen
high beam ................................HB3 (9005), 12-volt
low beam......................................HB4 (9006), 12V
License plate light..........................GE 53, 12-volt
Luggage Compartment...............GE 1141, 12-volt
Porch lights ...........................Jensen 1003, 12-volt
Rear clearance lights...................GE 194, 12-volt
Rear Turn lights..........................GE 1156, 12-volt
Side marker lights ........................GE 194, 12-volt
Stop/Turn/Taillights....................GE 1157, 12-volt
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt circuit breakers and 12-volt fuses
are located on three separate panels. The pur-
pose of these three panels is to provide electrical
circuit breakers and fuses to interrupt current
flow if a circuit is overloaded.
1.
120-volt House Electrical
— This electri-
cal panel is located under the bed or the
refrigerator (location varies depending
upon model). This panel is very similar to a
residential panel with resettable breakers.
2.
Fleetwood Automotive 12-volt System
—
This panel is located in a side compartment
or in the engine access compartment. This
electrical center contains battery disconnect
systems, entry step, fog light, and some other
automotive circuitry.
3.
12-volt Chassis Fuses
— This electrical
panel is located under the driver’s side
dash area.
04-5
CAUTION
Before relamping, disconnect power source by remov-
ing fuse or placing circuit breaker and control switch in
OFF position.
Halogen bulbs operate at extremely high temperatures
and pressures and will shatter if not handled correctly.
Always use a soft dry cloth or cotton gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with rub-
bing alcohol.
Do not use near flammable or combustible materials
and/or objects which may be sensitive to fading or drying.
Use bulbs designed or specific by manufacturer as to
style, wattage and voltage.
!
NOTE
Consult Chassis Operator’s/Owner’s Guide/Manual
for automotive lamp replacement on chassis cab. This
would include headlamps, turn signals and running
lamps.
WARNING
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or label. Doing so constitutes a fire hazard.
!