Clean Water Systems & Stores Inc 7000 Meter Greensand Filter Programming Guide 2010
backwashes. If your water hardness is 10 grains per gallon for example, set this to 10. If your
water test shows the hardness in PPM or mg/L, then divide this number by 17.1 to reach grains
per gallon. 1 grain per gallon = 17.1 ppm or mg/L of hardness.
6.
Reserve Selection (Display Code RS): Set to SF.
7.
Safety Factory (Display Code SF):
Set to 20. This will allow the softener to regenerate 200
gallons sooner to avoid having the softener resin get totally exhausted before it need s to
regenerate.
8.
Day Override (Display Code DO): Set to 7 to 14
. Use the Up or Down arrows to change the
setting. This will allow the softener to regenerate once every 7 to 14 days no matter how much
water is used. This is optional (can be set to 0) but it can be useful if you have iron or other
sediment to keep the softener clean.
9.
Regeneration Time: (Display Code RT): Set to 2:00 am
generally or sometime when no water
is being used, and no other filter or softener is likely to be in a regeneration cycle. Press the Extra
Cycle button.
10.
Regeneration Cycle Step Times:
Use this display to set the various minutes of each cycle.
Some of the cycles will be set to 0.
Do not set any of the cycles to Off
. Use the Up or Down
arrows to change the setting to the desired setting. Press the Extra Cycle button to accept the
setting and move to the next parameter.
a.
B1 – Backwash: Set to 8 minutes.
b.
BD - Brine Draw: Set to 60
c.
B2 - 2
nd
Backwash: Set to 6 minutes.
d.
RR - Rapid Rinse: Set to 6 minutes
e.
BF - Brine Fill:
30K grain softeners: set to 12 minutes. 48K grain softeners set to 20
minutes. 80K grain softeners: set to 32 minutes.
f.
SV - Service (meaning it is in Service or filtering mode) no setting is needed for
this.
Press the Extra Cycle button
11. Flow Meter Type (Display Code FM):
Set to t1.2 (which is standard Fleck 7000 meter). Press
the Extra Cycle button.
