I
M
P
O
R
T
A
N
T
Inside the amplifier case exist dangerous voltage levels.
The instrument cannot be powered from a DC-‐AC converter nor
from a solid-‐state AC generator with non-‐sinusoidal output.
Loads sensi@ve to voltage transients should be disconnected
from the amplifier during power-‐up and power-‐down.
Never connect the output to the input of the amplifier!
The amplifier may be overheated if the output is short-‐circuited
for a long @me.
The maximum allowable capaci@ve load depend on the internal
seSng of the slew rate. Overloading the output is likely to cause
overshoot. Slow down the amplifier to accommodate a larger
load.
It is recommended to monitor the output signal of the amplifier
on the oscilloscope.
ELECTRONICS AB
WWW.FLCE.SE