LIGHTING WITH A SPILL
Important do not light with a wax taper
In the unlikely event of the piezo ignition unit failing to light the fire, turn the control
knob to the OFF position, and wait a minute or so for the gas to disperse. The fire
can then be lit by using a spill.
a)
Remove the front casting by lifting upwards. Apply a lighted spill
at the pilot tip. Light the pilot by depressing the control knob at the “off”
position and turn anti-clockwise (with the control depressed) to the
second position marked *.
b)
When the pilot lights, remove the spill and continue to hold the control
knob down for 10 seconds.
c)
If the pilot fails to light, repeat the ignition sequence and hold in the
control knob for slightly longer.
d)
When the pilot has lit, refit the front casting, release the control knob
from the depressed position, depress slightly again and turn the control
anti-clockwise to the high position.
WARNING: The front casting MUST be fitted prior to turning the control knob
from the pilot position.
WARNING : Before attempting any cleaning operation ensure that the fire
has been allowed to fully cool.
CLEANING THE CASE.
Dusting is normally all that is required. But where extra cleaning is necessary, use
a damp cloth.
25
Note : Prior to replacing the oxypilot on this product due to suspected
failure of the component, please remove all debris that has collected on
the lint guard of the oxypilot itself.
