Flatworks plyfly, Инструкция по сборке

Страница: 50 / 79

150718
PL
YFL
Y
rev
A_GoKart
| Augu
st 7, 20
15 5:0
8 PM
Chapter 10
4
PART
Recommended tools
DESCRIPTION REFERENCE
Hammer
Required hardware
№ DESCRIPTION REFERENCE
2 Short Hex Bolt
Grade 5, 5/8”‑11, 6.5” L
PN 12503
2 Lock Nut
5/8” ID
PN 12506
4 Fender Washer
3/4” OD, 5/8” ID
PN 12505
Required assemblies
DESCRIPTION REFERENCE
7
Left Spindle
Assembly
PARTS 1, 3, 5, 7
8
Right Spindle
Assembly
PARTS 2, 4, 6, 8
Part 4 Install the steering spindles
INSTRUCTIONS
1. Slide the steering rack all the way to the right.
2. Insert
7
with the bolt facing out.
‒
Check that the bushings on
7
are completely seated
before installing.
Note the location and orientation of the assemblies.
3. Align the gear teeth of
7
with the gear alignment mark
located on the steering rack assembly gear.
Note the location and orientation of the alignment marks.
4. Insert the short hex bolt with a washer, starting from the
bottom and insert through the bushings found on
7
and
then through the top of the frame.
Note the order of the hardware insertion.
5. Using a hammer, tap into place.
6. Insert a washer over the short hex bolt and secure it with
a locknut.
Note the order of the hardware insertion.
7. Repeat steps 1 through 6 on the opposite side using
8
.
7
8
7
7
7
46 10 Putting the go‑kart together