07
Yes
No
Confirm
Are you sure you can’t finger
tighten these three knobs any
more?
Wait
Please tap [Verify] button to
check whether the distance
is appropriate now.
Verify
OK
Congrats
Tap [OK] button
to next point leveling.
2. Tap [Yes] if you can’t tighten all the nuts any more, or tap [No] to continue tightening.
After tapping [Yes] button, the extruder will move towards the first point and the plate
will move up and down to verify the distance between nozzle and plate.
3. If the distance between the nozzle and plate is too large, rotate the knob underneath the
platform clockwise until you hear a steady beep. If the distance is too small, rotate the knob
anticlockwise until you hear a steady beep.
4. Then tap the [Verify] button to check whether the distance is appropriate this time.
If the distance is appropriate now, tap [OK] to the second leveling point. If still not, please
follow the prompts to adjust again till you see [OK] button.
Repeat steps 3 and 4 to level the second and third points. Then tap [Finish] to exit.
Wait
Verifying the distance between nozzle
and plate...
Distance Too Big
Unscrew corresponding knob under
platform clockwise until hearing
a steady beep.
Distance Too Small
Screw corresponding knob under
platform anticlockwise until hearing
a steady beep.
Cancel
Cancel
