Pleese read these instructions cy, it includes important information about the
installation, usage and maintenance of this product.
Warning! Verify that the voltage select switch on your unit matches the line
voltage applied. Damage to your fixture may result if the line voltage applied
does not match the voltage indicated on the voltage selector switch. All fixtures
must be connected to circuits with a suitable Earth ground.
1. Preface
1.1 Packing list
Product name
quantity
Mini Moving Head Light
1 pcs
Unser Manual
1pcs
1.2 Unpacking ins truc tions
On receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are presented, and have been received in a good condition. Notify the
shipper immediately and retain packing material for inspection if any parts appear
damaged from shipping or the carton itself shows, sign of mishandling. Save the
carton and all packing materials. In the event that a fixture must be returned to the
factory , it is important that the fixture be returned in the original factory box and
packing.
1.3 AC Power
To determin the power requirements for a particular fixture, see the label affixed to
the back plate of the fixture or refer to the fixtures specifications chart. A fixture listed
current rating is its average current draw under normal conditions. All fixtures must
be directly powered off a switched circuit and cannot be run off a rheostat(variable
resisto) or dimmer circuit, even if the rheostat or dimmer source voltage matches the
fixtures requirement. Check the fixture or device carefully to make sure that if a
voltage selection switch exists that it sets to the correct line voltage you will use.
1.4 Safety instructions
Please keep this user guide for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
Always make sure that you are connecting to the proper voltage, and that the line
voltage you are connection to is not higher than that stated on the decal or rear panel
of the fixture.
This product is intended for indoor use only ! To prevent risk of fire or shock, do not
expose fixture to rain or moisture.
Make sure that there are no flammable materials close to the unit while operation.
The unit must be installed in a location with adequate ventilation, at least 20in(51cm)
from adjacent surfaces. Be sure that no ventilation slots are blocked.
Always disconnect from power source before servicing or replacing fuse and be sure
to be replaced with same fuse
，
size and type.
Secure fixture to fastening device using a safety chain. Never carry the fixture solely
by its head. Use its carrying handles.
