ASSEMBLY INSTRUCTIONS
Hardware Used
Cap nut
Screw M6X 10
x 3
x 9
x 3
STEP 6
WARNING: Remove protective cover before
assembling.
Note: If necessary, for proper alignment of reflector
sections. Attach 3 pcs reflector panels (A) to center
Reflector (B) using 9 pcs Screws M6x10 (II) and 9
pcs cap nuts (JJ). Fully tighten all the screws.
STEP 7
Attach 3 pcs reflector spacers (FF) and 3 pcs
washers (GG) to burner assembly (C) firstly.
Tighten the reflector spacers. Slide 3pcs washers
(GG) over threaded end of spacer.
Attach the reflector assembly to the top of reflector
spacer (FF) using 3 pcs washers (GG) and 3 pcs
wing nuts (KK).
Hardware Used
Reflector spacer
Wing nut
Washer
