Flash Furniture NAN-FSDC-01-SL-GG, Руководство пользователя

Страница: 13 / 15

................................................................................................................................................................................................
............................................................................................................................................................
OPERATION
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off”
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles
occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak is
repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
you must replace the hose (if applicable).
TO TURN THE HEATER ON
WARNING: Please ensure the glas s tube has not been damaged before operation
1. Ensure the variable control knob is at the OFF position
2. Connect the gas regulator to a compatible gas cylinder
3. Push and turn the variable control knob to the "Pilot " position and hold for 60
seconds. Whilst still holding the control knob down, press the ignition button. A pilot
flame should appear.
4. Once the blue pilot flame stays alight constantly, let go of the variable knob.
5. Turn the variable control knob to the desired temperature position – Lo to Hi
IMPORTANT NOTE
• When lighting the heater for the first time or a new LP cylinder is connected, the
air inside the hose must be purged. This process will take a few minutes as
liquefied petroleum gas is heavier than air
• As a result the variable control knob should be pressed down at the Pilot position
for 3 Minutes instead of the normal 60 second period
• This ensures the gas purges the air in the hose and passes from the cylinder
through to the main burner
TO TURN THE HEATER OFF
1. Turn the variable control to the PILOT position
2. Push and turn the variable control knob to the OFF position
3. Turn the regulator connected to the gas cylinder to the OFF position
Off: the heater stop s work ing
Hi: maximum temperature position
Lo: minimum temperature position