FLARM GPS-FilterBox 2.0, Руководство пользователя

Страница: 5 / 12

GPS-FilterBox 2.0 Manual | Installation 9
4.3. Typical use
In most cases the GPS-FilterBox can be connected to for example
your transponder using only two wires.
In most cases the wire connected to pin 6 of your RJ-12 connector
will be white. Connect this one to the ground pin of your
transponder. The wire on pin 5 (usually black) has to be connected
to the Rx of your transponder, see the picture below.
Figure 4: Typical use
10 Configuration | GPS-FilterBox 2.0 Manual
5. Configuration
The GPS-FilterBox is configured out of the box. The standard
configuration will mostly fit your needs.
5.1. Standard configuration
The table below shows all configurable items as configured when
new or after a hard reset.
Part Configuration
Input baudrate 19200 bps
Output baudrate 4800 bps
Filter
On
RMC sentences
Pass
GGA sentences Block
GSA sentences Block
On/off switch Enabled
Table 2: Standard configuration