9 |
P a g e
Fire controls (Manual)
•
The
on/off switch is located at the top of the opening on the right side; this is marked with
I/O
and will need to be switched to
I
to illuminate the flame effect.
•
The flame effect must be illuminated for the heater to work. For heating the controls are located
next to the on/off switch. For 750W of heat push in the switch marked with a single bar
I
. For
1.5kW of heat push in the switch marked with the double bars
II.
Both switches must be
depressed for 1.5kW of heat.
Fire controls (Remote)
•
The
on/off switch is located at the top of the opening on the right side; this is marked with
I/O
and will need to be switched to
I
to illuminate the flame effect via the remote control.
•
To turn the fire on, simply press and release the button on the remote keypad.
•
To set the light to your desired brightness, press then release the button marked
DIMMER or
. You will notice the flame effect brightness will continuously phase slowly from high to low.
At the desired point press then release the
DIMMER or
button to stop the phasing.
•
For heating the fire must be switched on. To give 1.5kW of heat, press then release the button
marked
O/I .
To turn the heater off, press then release again the button marked
O/I .
Thermostat information
The thermostat should be turned to maximum. Once the required room temperature is achieved turn
the thermostat towards minimum until you hear a click. The thermostat will then regulate the room
temperature automatically. There can be up to 2 or 3 degrees drop or rise in temperature for the
thermostat to activate or deactivate. The temperature is taken from around the fire unlike a wall
thermostat that is usually positioned around the middle of a room, so please allow for inaccuracies.
Situations such as room size or position of fireplace i.e. near a working radiator might cause the
thermostat not to work efficiently.
Operating 400 Series Manual & Remote Fires
Содержание 400 app
Страница 6: ...6 P a g e Atlanta Blazer...
