Plug fan GMEC with EC-motor - Operating instructions
3
FläktGroup DC_9942GB_20180604_R0
Specifications are subject to alteration without notice
CAUTION
The motor restarts automatically when operating voltage is ap-
plied, e.g. after a power failure.
Risk of injury
• Keep out of the motor’s danger zone.
• When working on the motor, switch off the line voltage and en-
sure that it cannot be switched back on.
• Wait until the motor comes to a stop.
2.5 ELECTROMAGNETIC RADIATION
Interference from electromagnetic radiation is possible, e.g. in
conjunction with open-and closed-loop control devices. If imper-
missible radiation levels occur following installation, appropriate
shielding measures have to be taken by the user.
NOTE Electrical or electromagnetic interference after installing the
device in customer equipment.
• Verify that the entire setup is EMC-compliant.
2.6 MECHANICAL MOVEMENT
DANGER
Ejected parts
Missing protective devices may cause balancing
weights or broken fan blades to be ejected and cause injuries.
• Take appropriate safety measures.
WARNING
Rotating device
Long hair and dangling items of clothing, jewelry and the like can
become entangled and be pulled into the device. Injuries can re-
sult.
• Do not wear any loose-fitting or dangling clothing or jewelry
while working on rotating parts. Protect long hair with a cap.
WARNING
Ejected parts
If the motor is operated with attached fan blades, missing protec-
tive devices may allow balancing weights or broken fan blades to
be ejected and cause injuries.
• Take appropriate safety measures such as installing guard
grilles.
• Keep out of the exhaust zone.
2.7 HOT SURFACE
CAUTION
High temperature on electronics housing
Risk of burns
Ensure sufficient protection against accidental con-
tact.
2.8 TRANSPORT
CAUTION
Transporting the motor
Crushing hazard
• Wear safety shoes and cut-resist-
ant safety gloves.
• Transport the motor in its original packaging only.
• Secure the device so it cannot slip, e.g. by using a lashing strip.
2.9 STORAGE
Store the device, partially or fully assembled, in a dry and weath-
erproof manner in the original packaging in a clean environment.
Protect the device against environmental effects and dirt until final
installation.
We recommend storing the device for no longer than one year in
order to guarantee trouble-free operation and the longest possible
service life.
Even devices explicitly intended for outdoor use are to be stored
as described prior to commissioning.
Maintain the storage temperature, see Chapter 4.2 Transport and
storage conditions.
Make sure that all cable glands are fitted with dummy plugs.
2.10 DISPOSAL
Comply with all relevant local requirements and regulations when
disposing of the device.
Item no. 55059-5-9970 · ENU · Change 88794 · Approved 2016-
03-17 · Page 2 / 11
Содержание CENTRIFLOW 3D PLUG FAN GMEC
Страница 15: ......
