- 6 -
START UP INSTRUCTIONS:
1. Connect the POL inlet on the regulator of the heater to the propane cylinder.
2. Open the cylinder valve.
3. Leak test the cylinder connection.
4. Plug in power supply to heater, Visually watch Power Supply Light
(See heater label if power is acceptable)
5. Depress the fan switch to the “ON” position. The fan motor will start and air will be
pushed through the outlet of the heater.
6. Depress the heat switch to the “ON” position. The burner should ignite and hot air
will be pushed through the outlet of the heater.
7. Set the Thermostat (if provided) to desired temperature.
8. If heater fails to ignite after 3 attempts call your supplier for service.
TO SHUT DOWN:
1. Close the cylinder valve on the propane cylinder.
2. Move “BURNER” switch to the “OFF” position, let fan run to 3 minutes, Move “FAN”
switch to the “OFF” position.
3. Disconnect heater from the cylinder.
