Flaem Masterneb P0404EM F400, Инструкция по эксплуатации

Страница: 5 / 68

The cap (C1.4) provided with the nebuliser RF6 Basic
2
makes it possible to deliver the
medication in 2 modes:
“standard mode”,
for optimum delivery and minimum
waste of medication
“high speed mode”
for a quicker treatment
6. Start the unit by means of switch (A1) and Inhale gently and deeply; after
inspiration we recommend to hold your breath for a moment in order to allow
inhaled aerosol droplets to deposit. Then, exhale slowly.
7. When the treatment is finished, turn off and unplug the unit.
WARNING: If after the therapy session moisture accumulates in the tube (B),
remove the tube from the nebulizer and dry it using the compressor air flow; this
operation will prevent mold from forming inside the tube.
of the unit. This must be positioned so that it is not difficult to make the
disconnection from the mains.
2. Assemble the nozzle as indicated in the “Assembly diagram” in point C1.2
Insert the complete nozzle in the bottom part (C1.1). Insert the Upper ven-
tilation cover (C1.4) in the upper part (C1.3) as shown in the “Connection dia-
gram” in point C1.
3. Pour the medication prescribed by the physician
into the lower part (C1.1). Close the nebuliser by
turning the upper part (C1.3) clockwise.
4. Connect accessories as indicated in the
“Connection diagram” on the cover.
5. Sit comfortably holding the nebuliser in your
hand, place the mouthpiece onto your mouth or
alternatively use the nose piece or mask. Should
you opt for the mask accessory, place it on your
face as shown in the picture (with or without using
the elasticated strap).
2 3