FK Motors FK 200, Руководство пользователя

Страница: 24 / 38

1. When the battery is removed, make sure that the main switch is at
OFF position to avoid short circuit.
2. Pay special attention that the positive and negative anodes of wires
should correspond to the positive and negative terminals of the
battery and are firmly connected. Loose connection will cause
damages or malfunctions to electrical components.
3. Inspect carefully after the installation. Avoid exposure of metal parts
of the wire to prevent leakages or other forms of danger.
Fuse
The fuse protects the circuits on the motorcycle. If a part of the circuit
fails, check and replace the fuse that has been blown. If a fuse is
repeatedly blown/damaged, there might be an electrical fault. Please
contact an authorised FKM workshop for further repairs.
Fuse inspection & replacement
Turn off the power switch, remove and inspect the fuse. If it is blown,
replace it with a similar specified new fuse.
Do not use other fuses other than the specified ones as it may
damage the electrical system. It may even cause a fire, blow the
electrical lamps or damage the engine.
Replacement of the fuse with a higher rated value can increase the
chance of damaging the electrical system.
Fuse box
The fuse box is located near the battery. Specifications of the fuse are as
follows:
Main fuse: 15A (On starting relay)
Auxiliary fuse: 10A (Lighting & electrical system control)
10A (Electronic fuel injection system control)
LED bulbs replacement
All bulbs installed onto this motorcycle are LED bulbs. If there are any
faulty LED bulbs, please contact your authorised FKM dealer.
Fuel pump assembly
The fuel pump feeds fuel from the fuel tank into the engine with controlled
amount and pressure.
●Amount of fuel in fuel tank to operate ≥ 2 litres
●Replace or clean coarse fuel filter for every 10000km travelled
●Replace fine fuel filter for every 12000km travelled
Page 23