Fixi 02RBZ, Руководство пользователя

Страница: 14 / 17

14
Push the battery (F) from under into the stand of the riveting machine, holding the locking
button (G) pressed. Push the battery into the stand completely until it is securely locked.
Changing nose pieces
The nose piece (A) is marked with numbers corresponding to the rivet diameters - section.
Hold the power switch (D) pressed, that will lead to the clamping mechanism moving into
the rear position. Use the included wrench SW 12 to switch to the required nose piece and
release the power switch.
Riveting
Insert the rivet into the nose piece (A) and the other end of the rivet into the work - pieces
to be riveted. Press the power switch until the rivet is removed, then release the power
switch. Tilt the riveting device backwards so that the removed rivet pin falls into the
mandrel collection device (C). If the rivet doesn't come off in a single working stroke,
repeat the procedure.
Failure
If rivets which exceed the indicated power of the device are used or if the battery is low or
overcharged, the device will stop operating and the red LED (H) will light up. Wait until the
red LED (H) turns off and press the power switch (D) for a short time. The device will revert
to the original position. If the battery is low, the device is powered down by a protective
circuit and the working tool will not move any more. Do not press the power switch again
after the riveting machine has been powered down automatically, this may lead to battery
damage.
Advise on optimal handling of the battery
Keep the battery away from wetness and water. Only store the battery at temperatures
from 0° to 45°C. Do not leave the battery in the car, e.g. in summer. If the battery is
working for significantly shorter periods of time after a recharge, it is used up and needs to
be replaced. Please consider the instructions for disposal.
Maintenance and service
Take the battery out of the battery riveting machine for transportation and storage. Risk of
injury occurs if you inadvertently press the power switch. Keep the electric riveting machine
and the ventilation slots clean to ensure good and safe operation.
If the battery riveting machine should fail despite the meticulous manufacturing and quality
control procedures, the repairs should be done by an authorized service center for the
battery riveting devices.
Please quote the serial number indicated on the label of the battery riveting machine
whenever turning to customer service or ordering spare parts.
Batteries:
Li-Ion: do not dispose of batteries in household waste, do not throw them into fire or water.
Batteries should be collected and recycled or disposed of in an environment - friendly way.
Only valid for European Union countries: According to European regulation 91/157/EWG,