Owner’s manual |
RMD802 - RMD802BH
10
RMD802 - RMD802BH
OPERATING INSTRUCTION
In order for your wireless system to work correctly, both the receiver and transmitter must be set to the same channel.
Follow the basic procedure for setting up and using your the wrieless system. Physically place the receiver where it will be
used, and extend the antennas vertically. With the Power switch on and receiver power off, connect the included power
adapter. Turn the receiver on momentarily to confirm that the unit is receiving power. You will see the LED display light up.
Then turn receiver power off.
With your amplifier or mixer off and volume control all the
way down: connect the receiver output jack to the mic or
line level input of a mixer or amplifier using the balanced
XLR output or unbalanced 1/4” line level output.
Turn the Level knob on the receiver completely counter-
clockwise, then turn its power on.
With the transmitter powered off, install two fresh AA batteries into the transmitter. Leave the battery compartment open.
Turn on the power to the transmitter by pressing and holding Power swith, the indicator LED will light green.
DC 15 V
300 mA
CH B OUT
BALANCED
AF OUT
UNBALANCED
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions
:
(1) This device may not cause harmful interference
,
and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
CH A OUT
BALANCED
FREQ: 806-810 MHz
ANT.A
ANT.B
POWER
LEVEL CH2
CH1C
H2
IR
READY
SEL
AF
READY
SEL
AF
LEVEL CH1
