20
ASSEMBLY
Step 9
9a. Tension Cable Connection
: As you begin to mount the
Hand Pulse Handlebar Support
Frame (41)
to the
Mainframe (59)
, insert the
Tension Cable (79),
coming out from the
Mainframe
(59)
, through the bottom opening in the shaft of the
Hand Pulse Handlebar Support Frame (41)
and pull it out through the shaft opening located near the top of the
Hand Pulse Handlebar
Support Frame (41)
. See
Figure G
.
9b. Sensor Wire Connection
: Connect the
Sensor Wire (78)
attached to the
Mainframe (59)
to
the
Extension Sensor Wire (10)
coming from the bottom end of the
Hand Pulse Handlebar
Support Frame (41)
. Make sure the connectors “click” when connected. See
Figure A
.
9c. Hand Pulse Handlebar Support Frame Installation
: Fully mount the
Hand Pulse Handlebar
Support Frame (41)
to the
Mainframe (59)
. After being mounted, secure the
Hand Pulse
Handlebar Support Frame (41)
onto the
Mainframe (59)
with four
Bolts (47)
, four
Spring
Washers (36)
, and four
Washers (24)
. Use the
6mm Allen Wrench with Phillips Screwdriver
to
tighten the bolts until they are all firm and secure.
Figure G
Figure A
Tool
6mm Allen Wrench with
Phillips Screwdriver
HARDWARE
(24) Washer
4PCS
(47) Bolt
4PCS
(36) Spring Washer
4PCS
7
Содержание AIR ELLIPTICAL
Страница 5: ...3 LABEL PLACEMENTS ...
Страница 8: ...6 OVERVIEW DRAWING ...
Страница 11: ...9 HARDWARE TOOLS PACK ...