FitLogic MIRACLE R280, Руководство пользователя

Страница: 27 / 84

26
TROUBLE SHOOTING GUIDE
1. No display on the console after the power is started:
The probable reason is that the wire from the console to the bottom
control board is not connected well or the transformer is burnt out.
Take off the upright frame tubes and check every single connection
part of the wires from the console to the bottom control board and
make sure that all the wires are connected well. If the problem is
caused by the defective wires or the defective transformer, please do
the replacement by the new wires or transformer.
2. E01—Communication failure:
The probable reason is that the communication from the console to the
bottom control board is
stuck. Check every single connection part of
the wires from the console to the bottom control board and make sure
that all the wires are connected well. If the problem is caused by the
defective wires, do the replacement by the new wires.
3. E02—Burst clash protection:
Check if the voltage is lower than 50% of the normal voltage and do
the testing again by the correct voltage. Check if the control board has
strange smell, if it is, please use a new control board to do the
replacement. Check if the motor wires are connected well, and
re-connect the motor wires well.
4. E03—No sensor signal:
The probable reason is that the speed sensor signal has not been
received during 10 minutes, check if the sensor signal light of the
bottom control board is flashing, if not, please use the new part to do
the replacement. Check if the sensor plug is connected well or if the
magnetic sensor is broken, re-connect the sensor plug or change the
magnetic sensor with the new one.
5. E04—Incline leaning failure:
Check if the VR wire of the incline motor is connected well, re-connect
the VR wire plug. Check if the AC wire of the incline motor is connected
well, connect the AC wire of the incline motor with the correct position
of the control board. Check if the motor connection wires are broken, if
yes, do the change by the new wires or the new incline motor. Press the
button of the bottom control board to re-work after all the checkings
are done well.
6. E05—Current overload protection:
The probable reason is that the user’s weight is over limit loading and