Fisheye FIX AQUAVOLT 10000, Руководство по эксплуатации продукта

Страница: 24 / 28

- 24 -
Regular overhaul is recommended once every 1-2 years, regardless of the frequency of use of
the product.
Waterproof O-rings that cannot be exchanged by customers are used inside of the product.
Please ask our customer service for overhaul after a certain period of time to exchange and
maintain these to prevent accidents and extend the life of the product.
Recommendation for Overhaul
Immediately stop using this product and remove any residual water inside of the light and the
battery. Do not put the battery back in the light body and store it separately. If there is some water
remaining inside, it may cause electric shock or damage to the circuit board therefore never use it
after water intrusion and contact Fisheye or your local retailer for service.
What to do In case of internal water contact
Using salt damage inhibitor SALT-AWAY included in the FIX maintenance kit, sold
separately, is even more effective.
1.Submerge the light body into fresh water for about 10-20 minutes before opening the light head
after use. Also activate Power Button and Dimmer Dial in fresh water several times and wash off
the salt deposits around buttons.
2.After removing from fresh water, rinse with slow flowing running water. Never use high pressure
water from one direction as it may cause water intrusion.
3.After rinsing, wipe off remaining water with a soft dry cloth. Do not dry in direct sunlight or dry
with a dryer or stove as it may cause failure, deformation or damage.
4.After use, lightly coat the O-ring with silicon grease and store. Replacing with a new O-ring once
a year is recommended.
5. For long time storage, avoid areas of extreme high temperature and humidity, direct sunlight or
extreme cold temperature.
6. Never use any organic solvents such as alcohol, benzene or thinner or neutral detergents as it
may cause deformation or damage.
After Use Care and Storage
After use in salt water, if salt deposits are allowed to remain and dry in small gaps,
salt crystals will form and will not subsequently dissolve. Make sure to submerge in
fresh water to wash off the salt deposits as these salt crystals may occasionally
push up the O-ring and cause water intrusion.
CAUTION
NOTE